CSDS Vinyl Foil Heat Transfer Vinyl
Metallic Foil Look with a Super Soft Feel!
Dazzle customers with this precious Foil HTV from yours truely! Available in 28 colors, CSDS Vinyl Foil HTV features show stopping shine with a smooth finish and soft hand that can be washed and worn without becoming lackluster. This fashion forward material is ideal for any project that needs a touch of gleaming metallic look!
Due to technological limitations, any colors shown are only representative of our products color and/or pattern. We can only guarantee that product colors will match their respective manufacturers’ color chart/swatch. Please test products and seek appropriate approvals prior to use in production.
Please allow for a ( /-) 1/2? error on all measurements.
Applies To:
Cricut®:
Blade: Standard
Setting: Iron-on
Blade: Standard
Setting: Iron-on
Silhouette Cameo:
Blade: Standard, 2
Setting: Heat Transfer Material (smooth)
Speed: 8
Thickness: 6
Blade: Standard, 2
Setting: Heat Transfer Material (smooth)
Speed: 8
Thickness: 6
Scan N Cut:
Blade: 2
Cut Speed: 1
Cut Pressure: 3
Blade: 2
Cut Speed: 1
Cut Pressure: 3
Roland GS/GX-24:
Blade: 45° Gram
Force: 80-90
Offset: .250
Speed: 30-50 cm/s
Blade: 45° Gram
Force: 80-90
Offset: .250
Speed: 30-50 cm/s
Graphtec:
Blade: 45°
Gram Force: 8-9
Tool: CB09U 0
Speed: 30 cm/s
Blade: 45°
Gram Force: 8-9
Tool: CB09U 0
Speed: 30 cm/s
Application instructions (home iron)
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• Peel carrier cold
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• Peel carrier cold
Application Instructions (heat press)
• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier cold
• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier cold
