Siser Sparkle Heat Transfer Vinyl
Make Your Designs Shimmer and Sparkle!
Sparkle Heat Transfer Vinyl is a fashionable alternative to Glitter HTV By Siser. Specially constructed to be soft to the touch, each color includes silver glitter specks embedded in the material so designs have a smooth finish. Sparkle is available in 14 colors, including silver and gold. Looking to layer? Sparkle can be layered for ultimate bling. Think outside the box and use Sparkle HTV on shoes, belts, and other hard-to-print items. If you like to keep it simple, Sparkle can be applied to t-shirts, hoodies, sweats and scrubs too!
Sparkle Applies To:
Cricut®:
Blade: Standard
Setting: Iron-on
Blade: Standard
Setting: Iron-on
Silhouette Cameo:
Blade: Standard, 2
Setting: Heat Transfer Material (smooth)
Speed: 8
Thickness: 4
Blade: Standard, 2
Setting: Heat Transfer Material (smooth)
Speed: 8
Thickness: 4
Scan N Cut:
Blade: 2
Cut Speed: 1
Cut Pressure: 1
Blade: 2
Cut Speed: 1
Cut Pressure: 1
Roland GS/GX-24:
Blade: 45° Gram
Force: 80-90
Offset: .250
Speed: 20-50 cm/s
Blade: 45° Gram
Force: 80-90
Offset: .250
Speed: 20-50 cm/s
Graphtec:
Blade: 45°
Gram Force: 8-9
Tool: CB09+0
Speed: 30 cm/s
Blade: 45°
Gram Force: 8-9
Tool: CB09+0
Speed: 30 cm/s
Application instructions (home iron)
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• Peel carrier hot or cold
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• Peel carrier hot or cold
Application Instructions (heat press)
• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot or cold
• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot or cold
