Access Denied
IMPORTANT! If you’re a store owner, please make sure you have Customer accounts enabled in your Store Admin, as you have customer based locks set up with EasyLockdown app. Enable Customer Accounts
StripFlock® Pro Heat Transfer Vinyl
The only flock in the industry that can be layered on itself!
A great alternative to embroidery, StripFlock Pro heat transfer vinyl gives logos a raised, textured, suede-like feel. The deep, opaque colors make StripFlock Pro excellent for retro designs like you'd find in a mall in the 80's, or anytime you want a deep, rich look. StripFlock Pro looks excellent on caps, bags, and garments that need textured visual interest. Use Stripflock Pro as a base layer and cover with other materials such as EasyWeed Stretch for an embossed look, or layer with more StripFlock! The ability to layer this material allows you to say “yes” to multi-color designs. Want to stand out even more?
StripFlock Pro is 410 Microns / 16.1 mils and is a PU composition.
EasyWeed Applies To:
Cricut®:
Blade: Standard
Setting: Iron-on
Blade: Standard
Setting: Iron-on
Silhouette Cameo:
Blade: Standard, 4
Setting: Heat Transfer Material (Flocked)
Speed: 5
Thickness: 6
Blade: Standard, 4
Setting: Heat Transfer Material (Flocked)
Speed: 5
Thickness: 6
Scan N Cut:
Blade: 4
Cut Speed: 1
Cut Pressure: 2
Blade: 4
Cut Speed: 1
Cut Pressure: 2
Roland GS/GX-24:
Blade: 45° Gram
Force: 80-120
Offset: .250
Speed: 30 cm/s
Blade: 45° Gram
Force: 80-120
Offset: .250
Speed: 30 cm/s
Graphtec:
Blade: 45°
Gram Force: 17
Tool: CB09U 0
Speed: 30 cm/s
Blade: 45°
Gram Force: 17
Tool: CB09U 0
Speed: 30 cm/s
Application instructions (home iron)
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• Peel carrier hot or cold
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• Peel carrier hot or cold
Application Instructions (heat press)
• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier warm
• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier warm
Invalid password
Enter